WIKA CPH6200 User Manual

Page 18

Hand-Held Pressure Indicator
CPH6200-S1 / CPH6200-S2

11221780.1.3 01/2009 GB/D/F/E

WIKA Operating Instructions Hand-Held Pressure Indicator

Max. number of measurements:

The data recorded includes the following values:

Sensor 1 instantaneous value at that data point
Sensor 1 Min-Peak, Max-Peak since last data point
Sensor 2* instantaneous value at that data point
Sensor 2* Min-Peak, Max-Peak since last data point
Instantaneous difference (Sensor 1 - Sensor 2)* at that data point
Min-Peak, Max-Peak of the difference (Sensor 1 - Sensor 2)*, Min-
Peak, Max-Peak since last data point
Time and date stamp of that data point

* Only for 2-channel version CPH6200-S2

After each recording “St. XX“ will be displayed for a short time. XX
represents the number of the data point.

If the logger memory already contains data:
When the

´Store/Quit´ key is pressed for 2 seconds, the option to clear

the logger memory will be displayed:

clear

clear nothing

all data points

(cancel menu)

clear the last

data point

Use the

´Min´ or the ´Max´ key to display the required option. The

´Store/Quit´ key selects that choice.

If the logger memory is full, the display will show:

Viewing Recorded Measurements
Within the “LoGG-Stor“ function the measurements can be viewed
directly on the instrument display as well as through a computer (“Func-
CYCL“ only allows for the data to be viewed on computer). Press the
´Set/Menu´ key for 2 seconds: The first menu displayed is now “rEAd-
LoGG“ (read logger data). By then pressing the

´Tare´ key, the last

measurement recorded will be displayed; pressing the

´Tare´ key again

scrolls between the different values related to this data point.
Pressing the

´Min´ key or ´Max´ key selects different data points.








