Kramer Electronics 711xl User Manual

Page 10

The 707 and 708 Video Audio Line Transmitter and Receiver

4.3 Connecting the 707/708 Video Audio Line Transmitter/Receiver

You can use the

707 and 708 to configure a video audio line transmitter and

receiver system.
To connect the

707 Video Audio Line Transmitter with the 708 Video Audio

Line Receiver, as illustrated in the example in Figure 3, do the following:

1. Connect a composite video source (for example, a video player) to the VIDEO

IN BNC connector of the

707.

2. Connect an unbalanced mono audio source (for example, the audio

output of the video player

) to the AUDIO IN RCA connector of the

707.

3. Connect the VIDEO OUT BNC connector of the

708 to a composite

video acceptor (for example, a display).

4. Connect the AUDIO OUT RCA connector of the

708 to an unbalanced

mono audio acceptor (for example, an amplifier with speakers).

5. Connect the LINE OUT RJ-11 connector of the

707 to the LINE IN RJ-11

connector of the

708, via twisted pair cabling.

6. If required, connect the LOOP RJ-11 connector to the LINE IN RJ-11

connector of an additional

708 unit.

7. On each

707 / 708 unit, connect a 12V DC power adapter to the power socket

and connect the adapter to the mains electricity (not illustrated in Figure 3).

8. If required, adjust the AUDIO LEVEL on the

707 and the EQ

(equalization) and VIDEO GAIN levels on the

708, by inserting a

screwdriver into each of the small holes and carefully rotating them.

1 Alternatively, you can connect a condenser microphone and press the COND. MIC push button

This manual is related to the following products: