Kramer Electronics VS-88HDxl - Manual (Page 31)

Kramer Protocol 3000
27
27
10 Kramer Protocol 3000
The VS-88HDxl can be operated using serial commands from a PC, remote
controller, or touch screen. The unit communicates using the default Kramer
Protocol 3000 but can also use Kramer Protocol 2000.
This section describes:
• How to switch between Protocol 3000 and Protocol 2000 (see
section 10.1 )
• Kramer Protocol 3000 syntax (see section
10.2 )
• Kramer Protocol 3000 commands (see section
10.3 )
10.1 Switching Protocols
Protocols can be switched either from the front panel buttons or by
transmitting protocol commands.
To switch protocols using the front panel buttons:
• To choose Protocol 2000, press LOCK and OUT 2 at the same time
• To choose the Protocol 3000, press LOCK and OUT 3 at the same
time
To switch protocols using protocol commands:
• To switch from Protocol 3000 to Protocol 2000, send the following
command:
#P2000
• To switch from Protocol 2000 to Protocol 3000, send the following
command:
0x38, 0x80, 0x83, 0x81
Note: If you are using Kramer’s Windows®-based control software
1
it
operates only with Protocol 2000. If the VS-88HDxl is set to Protocol 3000,
it automatically switches to Protocol 2000.
1 Download the latest software from our Web site at http://www.kramerelectronics.com