Kramer Electronics VS-88DTP - Manual (Page 50)

46 VS-88DTP - Kramer Protocol
Identification commands
Command Syntax Response
Read machine name NAME? NAME MACHINE_NAME
Reset machine name to
factory default*
NAME-RST NAME-RST
MACHINE_FACTORY_NAME
RESULT
*Note: machine name not equal to model name. This name relevance for site viewer identification of
specific machine or for network using (with DNS feature on).
MACHINE_NAME = Up to 14 Alfa-Numeric chars.
*
Machine factory name = Model name + last 4 digits from serial number.
Network Setting Commands
Set IP Address NET-IP IP_ADDRESS
NTIP
NET-IP IP_ADDRESS RESULT
Read IP Address NET-IP?
NTIP?
NET-IP IP_ADDRESS
Read MAC Address NET-MAC?
NTMC
NET-MAC MAC_ADDRESS
Set subnet mask NET-MASK SUBNET_MASK
NTMSK
NET-MASK SUBNET_MASK
RESULT
Read subnet mask NET-MASK?
NTMSK?
NET-MASK SUBNET_MASK
Set gateway address NET-GATE GATEWAY_ADDRESS
NTGT
NET-GATE GATEWAY_ADDRESS
RESULT
Read subnet mask NET-GATE?
NTGT?
NET-GATE GATEWAY_ADDRESS
Set DHCP mode NET-DHCP DHCP_MODE
NTDH
NET-DHCP DHCP_MODE RESULT
Read subnet mask NET-DHCP?
NTDH?
NET-DHCP DHCP_MODE
DHCP_MODE =
0 – Don't use DHCP (Use IP set by factory or IP set command).
1 – Try to use DHCP, if unavailable use IP as above.
Change protocol ethernet
port
ETH-PORT PROTOCOL , PORT
ETHP
ETH-PORT PROTOCOL ,PORT
RESULT
Read protocol ethernet
port
ETH-PORT? PROTOCOL
ETHP?
ETH-PORT PROTOCOL , PORT
PROTOCOL = TCP / UDP (transport layer protocol)
PORT
= ethernet port to enter protocol 3000 commands.
1-65535 = User defined port
0 - reset port to factory default (50000 for UDP, 5000 for TCP)