Kramer Electronics VS-88DTP - Manual (Page 14)

10 VS-88DTP - Connecting the VS-88DTP
5 Connecting the VS-88DTP
Always switch off the power to each device before connecting it to your
VS-88DTP. After connecting your VS-88DTP, connect its power and
then switch on the power to each device.
To connect the VS-88DTP as illustrated in the example in Figure 3 :
1. Connect up to eight DVI sources (for example, computer graphics sources)
to the IN 1 to IN 8 DVI connectors.
You do not have to connect all the sources.
2. Connect the OUT 1 to OUT 8 TP connectors to up to eight TP receivers (for
example, the PT-572HDCP+ and TP-574).
You do not have to connect all the outputs.
3. If required, connect a controller to the RS-232 (see Section 5.1 ) and/or
Ethernet port (see Section 5.3
4. Connect the power cord (not shown in
).
Figure 3 ).
5. If required, acquire the EDID (see Section 6.5
i
).