Kramer Electronics VS-44HDxl - Manual (Page 22)

Operating the VS-44HDxl
19
7 Operating the VS-44HDxl
You can operate your VS-44HDxl via:
The front panel buttons
RS-232/RS-485 serial commands transmitted by a PC, touch screen system,
or other serial controller
The Kramer RC-IR2 Infra-Red Remote Control Transmitter
The Infra-red remote extension cable transmitter
The ETHERNET
7.1 Switching OUT-IN Combinations
Section 7.1.1 describes how to switch OUT-IN combinations and section 7.1.2
how to switch OUT-IN combinations in the dual link mode.
Note that:
The OUTPUT button color changes during routing according to the input
button color: green (for standard definition) or blue (for high definition)
If an OUTPUT button is not selected, that button will not illuminate
If a source is connected to an INPUT, that INPUT button will illuminate
7.1.1 Switch OUT-IN Combinations
To switch an input to an output, via the front panel buttons 1 , in the AT ONCE
mode (see section 7.2), do the following:
1. Press an OUTPUT button (either 1, 2, 3, 4 or ALL).
The selected OUTPUT button illuminates brightly, as does the 7-segment
display.
2. Press an INPUT button (either 1, 2, 3, 4 or OFF) 2 .
The selected input switches to the selected output, and that input button
illuminates brightly. The digits displayed in the 7-segment display change
as appropriate.
1 For details of how to route an input to an output using the REMOTE connector, see section 6.9
2 For immediate switching