Kramer Electronics VS-44HDxl - Manual (Page 2)

Contents
i
Contents
1 Introduction 1
2 Getting Started 1
2.1 Quick Start 1
3 Overview 3
4 Your VS-44HDxl 3G HD/SD-SDI 4x4 Matrix Switcher 4
4.1 Using the IR Transmitter 7
5 Installing on a Rack 8
6 Connecting Your VS-44HDxl 3G HD/SD-SDI 4x4 Matrix Switcher 9
6.1 Connecting the VS-44HDxl in the Dual-Link Mode 11
6.2 Working Mode Setting 12
6.3 Dipswitch Setting 13
6.3.1 Setting the Machine # Dipswitches 13
6.4 Controlling via RS-232 (for example, using a PC) 14
6.5 Controlling via the RS-485 Port 15
6.6 Factory Reset 15
6.7 Switching Genlocked Video Signals 16
6.8 Controlling via ETHERNET 16
6.8.1 Connecting the ETHERNET Port directly to a PC (Crossover Cable) 16
6.8.2 Connecting the ETHERNET Port via a Network Hub (Straight-Through Cable) 18
6.8.3 Configuring the Ethernet Port 18
6.9 Controlling via the REMOTE Connector 18
7 Operating the VS-44HDxl 19
7.1 Switching OUT-IN Combinations 19
7.1.1 Switch OUT-IN Combinations 19
7.1.2 Switch OUT-IN Combinations in the Dual-Link Mode 20
7.2 Confirming Settings 20
7.2.1 Toggling between the AT ONCE and CONFIRM Modes 20
7.2.2 Confirming a Switching Action 21
7.3 Storing/Recalling Input/Output Configurations 21
7.3.1 Storing an Input/Output Configuration 21
7.3.2 Recalling an Input/Output Configuration 22
7.4 Locking the Front Panel 22
8 Technical Specifications 23
9 Table of Hex Codes for Serial Communication 23
10 Kramer Protocol 2000 24