Kramer Electronics VS-42HC - Manual (Page 25)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating the VS-42HC
22
Decrease or increase the delay time by looking and listening, until you see
that the audio is synchronized with the video.
3. Once the delay time is set, press the DELAY button again to accept the delay
time value.
The DELAY button illuminates.
The maximum delay time is set according to the input sampling rate 1 , as
described in Table 10:
Table 10: Maximum Delay Time according to Sampling Rate
Sampling Rate
[kHz]
Maximum Delay Time
[ms]
32 999
44 720
48 680
96 340
To cancel the delay time, press the DELAY button once again.
The DELAY button light turns off.
To reset the delay time to 0 (zero), press and hold the DELAY button for a
few seconds.
Table 11 summarizes the way the DELAY button responds.
Table 11: DELAY Button Response
When the DELAY button: Then:
Blinks You can view the sampling rate and the delay time
value, or adjust the delay time
Illuminates OUT 2 audio delay is on
Is not illuminated OUT 2 audio delay is off
Is pressed for a few seconds Delay time resets to 0 (zero)
1 The sampling rate is specified by the source signal and cannot be changed by the switcher. The switcher automatically
adjusts the maximum delay time value according to the sampling rate