Kramer Electronics VS-121HC - Manual (Page 8)

Your VS-121HC Switcher / Transcoder
5
Table 1: VS-121HC Front Panel Features
# Feature Function
1 IR Receiver The red LED is illuminated when receiving signals from the infra-red
remote control transmitter
2 POWER Switch Illuminated switch for turning the unit ON or OFF
3 COMPOSITE INPUT Buttons Select the composite video input (1 to 4) to switch to the outputs
4 s-VIDEO INPUT Buttons Select the s-Video input (5 to 8) to switch to the outputs
5 COMPONENT INPUT Buttons Select the component video input (9 to 12) to switch to the outputs
6 PANEL LOCK Button Disengages the front panel buttons
Table 2: VS-121HC Rear Panel Features
# Feature Function
7 CV IN RCA connectors Connect to the composite video sources (from IN 1 to IN 4)
8 s-VIDEO IN s-Video connectors Connect to the s-Video sources (from IN 5 to IN 8)
9 COMPONENT
INPUT
RCA connectors
Y Connect to the Y-component inputs (from IN 9 to IN 12)
10 PB/CB Connect to the PB/CB -component inputs (from IN 9 to IN 12)
11 PR/CR Connect to the PR/CR -component inputs (from IN 9 to IN 12)
12 COMPONENT
OUTPUT
RCA connectors
Y Connect to the Y-component outputs (A and B)
13 PB/CB Connect to the PB/CB -component outputs (A and B)
14 PR/CR Connect to the PR/CR -component outputs (A and B)
15 RS-232 9-pin D-sub (F) Port Connect to the PC or the Remote Controller via a null-modem
connection
16 RS-485 Terminal Block Port Pins B (-) and A (+) are for RS-485; Pin G may be connected to the
shield (if required)
17 FLASH PROG Button Release (the factory default) for normal operation or push in
1
9.1.1
for
“Program” to upgrade the switcher microcontroller to the latest Kramer
firmware (see
section )
18 ETHERNET RJ-45 Connector Connects to the PC or other Serial Controller through computer
networking LAN
19 FACTORY RESET Button Press to reset to factory default definitions
2
IP number
− 192.168.1.39
:
Mask – 255.255.255.0
Gateway – 192.168.1.1
20 ETH PROG Button Release for normal operation or push in to upgrade ETH firmware
(see section 9.2 )
21 REMOTE IR 3.5mm Mini Jack Connect to an external IR receiver unit for controlling the machine via an
IR remote controller (instead of using the front panel IR receiver)
3
22 Setup DIP-switches DIP-switches for setup of the unit (1 through 7 are for setting the
Self Address number; and 8 is for RS 485 termination)
23 Power Connector with Fuse AC connector enabling power supply to the unit
1 Using a screwdriver if required
2 Turn the machine OFF, then turn the machine ON while pressing the FACTORY RESET button. The unit powers up and
loads its memory with the factory default definitions
3 Optional. Can be used instead of the front panel (built-in) IR receiver to remotely control the VS-121HC (only if the internal
IR connection cable has been installed)