Kramer Electronics VS-121HC - Manual (Page 10)

Connecting the VS-121HC Switcher/Transcoder
7
6 Connecting the VS-121HC Switcher/Transcoder
To connect devices to the VS-121HC, as illustrated in the example in
Figure 2 , perform the following
1
1. Connect the following video input sources (up to 12 input devices can
be connected
:
2
 One composite video source (for example, composite video player
1) to the CV IN 1 RCA connector
):
 One s-Video source (for example, s-Video player 1) to the s-Video
IN 8 4-pin connector
 One component video source (for example, composite video player
1) to the Y, Pb/Cb, Pr/Cr COMPONENT INPUT 12 RCA
connectors
2. Connect the output to an acceptor (1 or 2 output devices can be
connected
1
):
 COMPONENT OUTPUT B (Y, Pb/Cb, Pr/Cr RCA connectors) to a
display
3
3. Connect the power cord (not shown in Figure 2 ).
4. Optionally, you can connect a PC or controller to the RS-232, RS-485,
or Ethernet ports (see section 7 ) and/or an IR remote transmitter (see
section 7.5 ).
1 Switch OFF the power on each device before connecting it to your VS-121HC. After connecting your VS-121HC, switch on
its power and then switch on the power on each device
2 Not all input or output ports need to be connected
3 In this example an LCD TV display is used, but you can also connect separate outputs such as video recorders, and so on