Kramer Electronics VP-1608 - Manual (Page 23)

VP-1608 - Operating Your VP-1608 16x8 RGBHV/Balanced Audio Matrix 19
7.3 Confirming Settings
Choose to work in the AT ONCE or the CONFIRM mode, as explained in Section
7.3.1 . When the VP-1608 operates in the AT ONCE mode, pressing an OUT-IN
combination implements the switch immediately. In the CONFIRM mode, the
TAKE button must be pressed to authorize the switch.
In the AT ONCE mode, you save time as execution is immediate and actions
require no user confirmation. However, no protection is offered against changing
an action in error.
In the CONFIRM mode:
• You can key-in several actions and then confirm them by pressing the TAKE
button, to simultaneously activate the multiple switches
• Every action requires user confirmation, to protect against erroneous
switching
• Execution is delayed until the user confirms the action
Failure to press the TAKE button within one minute (the timeout) aborts the action.
7.3.1 Toggling between the AT ONCE and CONFIRM Modes
To toggle between the AT ONCE and CONFIRM modes, do the following:
1. Press the TAKE button to toggle from the AT ONCE mode (the TAKE button
does not illuminate) to the CONFIRM mode (the TAKE button illuminates).
The TAKE button illuminates and actions now require user confirmation.
2. Press the illuminated TAKE button to toggle from the CONFIRM mode back
to the AT ONCE mode.
The TAKE button turns off and actions no longer require user confirmation.