Kramer Electronics VP-300T User Manual

Page 20

Connecting the VP-200XLT

3. Connect the LINE OUT RJ-45 connector on the

VP-200XLT to the LINE

IN RJ-45 connector on the

TP-120, via UTP cabling (with a range of more

than 300ft (more than 100m)), see section 11.1.

4. Connect the 12V DC power adapter to the power socket on the

VP-200XLT, and plug the adapter into the mains electricity socket.

Similarly, connect the other 12V DC power adapter to the power socket on

the

TP-120, and plug that adapter into the mains electricity socket.

5. On the

VP-200XLT, if required, rotate the appropriate control knob to

adjust the:

Video output signal level
Cable compensation equalization level

6. On the

TP-120, if required:

Adjust

the video output signal level and/or cable

compensation equalization level

Set the H SYNC and V SYNC switches

, on the underside

1 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level
2 By default, both switches are set down (for normal V SYNC and H SYNC polarity)

This manual is related to the following products:

VP-200xlT