Kramer Electronics VM-28H - Manual (Page 19)

16 VM-28H, VM-216H - Using the VM-28H/VM-216H
5.4.1 Acquiring / Changing the EDID from One Output
To acquire or change the EDID of a new output display:
1. Connect the power supply.
2. Connect the new output display device.
3. Press the EDID button for more than 3 seconds.
4. Press an input button (either IN 1 or IN 2) once (depending if you want to
copy the new EDID to input 1 or to input 2).
The selected input button illuminates.
5. Enter the One output mode as defined in Section 5.4 (with either IN 1 or
IN 2).
6. Press that input button to set the appropriate OUTPUT STATUS LED. The
OUTPUT STATUS LED illuminates indicating that that output channel is
selected.
7. Press the LOCK button to copy the EDID of the selected OUTPUT to the
input.
While the EDID is being copied the EDID button flashes. The new EDID is
copied, when the EDID button no longer flashes.
5.4.2 Acquiring the Default EDID
To reset the default EDID, do the following:
1. Connect the power supply.
2. Press the EDID button for more than 3 seconds.
3. Press an input button (either IN 1 or IN 2) once.
The selected input button illuminates.
4. Enter the default mode as defined in Section
5.4
(with either IN 1 or IN 2).
All the OUTPUT STATUS LEDs flash simultaneously.