Kramer Electronics VM-28H - Manual (Page 14)

VM-28H, VM-216H - Using the VM-28H/VM-216H 11
5 Using the VM-28H/VM-216H
This section describes how to:

Connect the VM-28H/VM-216H, see Section
5.1

Control the VM-28H/VM-216H via RS-232, see Section 5.2

Operate the VM-28H/VM-216H, see Section 5.3

Use the EDID button, see Section 5.4
5.1 Connecting the VM-28H/VM-216H
Always switch off the power to each device before connecting it to your
VM-28H, VM-216H. After connecting your VM-28H, VM-216H, connect
its power and then switch on the power to each device.
This section describes how to connect the:

VM-28H, see Section 5.1.1

VM-216H, see Section 5.1.2
5.1.1 Connecting the VM-28H 2 Input 1:8 HDMI Distributor
To connect the VM-28H, as the example in Figure 2 shows, do the following:
1. Connect the HDMI OUTPUT connectors (as required, up to 8 outputs can be
connected, not all outputs need to be connected) to up to 8 HDMI acceptors,
using Kramer HDMI copper cables. In this example, connect the:

OUTPUT 1 connector to acceptor 1 (for example, a plasma display)

OUTPUT 2 connector to acceptor 2 (for example, an LCD TV)

OUTPUT 7 connector to acceptor 7 (for example, an LCD TV)
 OUTPUT 8 connector to acceptor 8 (for example, a plasma display)
2. Connect the two HDMI sources, for example, a DVD player and a set top
box, to the INPUT 1 and INPUT 2 connectors, respectively, using the Kramer
HDMI copper cables.
i