Kramer Electronics VM-28H - Manual (Page 10)

7
Figure 3: VM-216H 2-Input 1:16 HDMI Distributor Front Panel
# Feature Function
1 IR Receiver The red LED is illuminated when receiving signals from the Kramer Infrared remote control transmitter
2 POWER Switch Illuminated switch for turning the unit ON or OFF
3 IN 1 Button Press to select source 1 and distribute this signal to the outputs (when the EDID button does not
illuminate). Also used for acquiring/changing the EDID (see
Section 5.4 )
Illuminates when selected and there is a signal, flashes when selected but there is no signal
4 IN 2 Button Press to select source 2 and distribute this signal to the outputs (when the EDID button does not
illuminate). Also used for acquiring/changing the EDID (see
Section 5.4 )
5 EDID Button Press for more than 3 seconds to set to the EDID mode
Illuminates when configuring the EDID. When the EDID button does not illuminate the machine is in
Distribution mode (lets you distribute an input signal to the outputs)
6 LOCK Button Press to engage/disengage the front panel switches
Illuminates when the front panel switches are locked, pressing another button causes the LOCK button to flash
once warning that you need to unlock to regain control via the front panel. The LOCK button also flashes (the
IN 1, IN 2 and EDID buttons do not flash at the same time) when the machine is busy (perhaps searching
between signals) and no operation is permitted. When powering up, the VM-216H front panel is automatically
locked
7 OUTPUT STATUS LEDs LEDs light when an output(s) is connected and active; LEDs flash when selecting the EDID (see
Section 5.4 ) or when connecting a non-HDCP display while providing HDCP content to the
VM-216H
The specific OUTPUT STATUS LEDs flash when the outputs are not HDCP compatible