Festo Направляющая FDG - Manual (Page 20)

FDG−...
Festo FDG−... 0612a English
20
In order to scan the slide positions:
S use sensors with inductive switching principle together with ferritic switching tags.
Due to the clean outer slide, the FDG does not possess magnets.
You can protect unused sensor grooves from dust deposits by using cover rails.
6 Commissioning
If the emergency buffers are used:
S Check to see if the support of the emergency buffer is displaced or is damaged
asymmetrically.
If this is the case, the support KYP−... must be positioned again.
When doing this, make sure that you tighten the clamping screws again.
S Pull gently on the adhesive connection between the emergency buffer and the
support.
If the adhesive layer or the emergency buffer is damaged, you must replace the
emergency buffer completely.
7 Care and maintenance
Lubricating the roller bearing guides types FDG−...−KF:
S Observe the lubricating intervals:
Lubricant type 1. Interval 2. ... n. Interval
FDG−8 ... 18 FDG−25 ... 63
Festo special grease LUB−KC1 5000 km 400 km
Festo special grease LUB−RN2 5000 km 400 km 5000 km
Fuchs Notropeen LXG00 5000 km 5000 km not permitted
Fig. 16: Lubricants und lubrication intervals