Festo Промежуточная позиция для линейного модуля DGC - Manual (Page 21)

SLG−Z−...
Festo SLG−Z−... 0512a English
21
Both end stops (A) of the SLG−... must
then be removed and fitted again at the
same height in the groove (B) of the
fastening rail.
2. Fasten the cushioning support with cenĆ
tring pins and the fastening screw supĆ
plied to the slide of the linear drive (e.g.
type SLG−...).
Make sure that the alignment is correct. If
fitted correctly, the cushioning support
will be below the edge of the slide of the
SLG−... (see Fig. 11).
S Fasten the fastening rail type SLG−S−... as
follows:
Place the fastening rail type SLG−S−... on
the profiled edge (C), position it with
dowel pins (D) and tighten with screws in
all the fastening holes. The supporting
surface must be level (see operating inĆ
structions for type SLG−...).
The tightening torques are shown in the
table below:
Fig. 10
(A)
(B)
Fig. 11
d
Fig. 12
(C)
SLG−S−...
Fig. 13
(D)