SawStop Mobile Base - Manual (Page 4)

SawStop Professional Cabinet Saw Mobile Base
Installing Your Mobile Base - Method 1
. Locate all of the mobile base components shown on page 1. All of the hardware needed to install the mobile
base is located on the hardware pack (see Fig. ). In order to easily identify the hardware used in each of
the following steps, the different pieces of hardware are numbered on the hardware pack and in the figures.
If you are missing the hardware pack or any of the other mobile base components, call the SawStop Service
Department at 503-582-9934 for replacements.
You will need the following tools to complete the
mobile base installation:
• a 5 mm hex key
• a 6 mm hex key
• a 10 mm socket
• a 10 mm wrench
• a 14 mm wrench
• a 17 mm wrench
1. You need access to the bottom of your saw to
install the mobile base. The easiest and safest
way to provide that access is to leave the saw
facing up on the packaging and slide it so that
the bottom of the cabinet overhangs the edge
of the packaging as shown in Fig. 1. The saw
should overhang the packaging enough to clear
the rectangular and circular holes around the
bottom of the cabinet.
Fig. 1
STaRT HeRe to install your mobile base on a new
Professional Cabinet Saw that has not yet been assembled.
Fig.
Professional Cabinet Saw Mobile Base Hardware Pack
Extension Spring, (1) 8
Lock Washers,
M8 x 13.6 (4) 2
Washers,
M8 x 18 (2) 4
Washers,
M6 x 16 (2) 14
Flange Lock
Nuts, M6 (2) 15
Hex Bolts,
M6 x 40 (2) 13
Lock Washers,
M10.5 x 17 (4) 11
Caster Nuts,
3/8” thread (2) 16
Button Head Socket
Bolts, M8 x 35 (2) 1
Lock Nuts,
M6 (2) 7
Shoulder Socket
Screw, M8 x 17.7 (1) 9 Button Head Socket
Bolts, M10 x 40 (2) 10
Washers,
M10.5 x 20 (4) 12
Button Head Socket
Bolts, M8 x 20 (2) 3
Button Head Shoulder
Socket Bolts, M8 x 20 (2)
5
Fixed Wheel Axles 6
saw overhangs
the edge of the
packaging