Installing your mobile base - method 1 – SawStop Mobile Base User Manual

Page 10

SawStop Professional Cabinet Saw Mobile Base

Installing Your Mobile Base - Method 1

14. Align the front end of the wheel support with

the mounting hole in the lower left corner

of the front of the cabinet. Secure that end

of the wheel support to the cabinet with an

M8 x 20 button head shoulder socket bolt

(see Fig. 14). Note that this bolt is different

than the bolt used to secure the rear of the

wheel support to the cabinet. Fully tighten

the bolt using a 5 mm hex key.

Fig. 14

15. You must now connect the pedal

assembly to the linkage bar. There

is a slot in the linkage bar near the

pedal assembly and there is a plastic

washer and threaded hole on the

pedal assembly near the linkage

bar. Pivot the linkage bar and the

pedal assembly until the slot in the

linkage bar aligns with the plastic

washer and the threaded hole in the

pedal assembly. Insert an M8 x 17.7

shoulder socket screw through the

slot in the linkage bar and thread it

into the hole in the pedal assembly

(see Fig. 15). Fully tighten the screw

with a 5 mm hex key.

16. Stand up your saw as described in step 4 on the back of the unpacking sheet that came with your saw

and also in your Professional Cabinet Saw Owner’s Manual. With the saw in the upright position, mount the

caster extension bar to the

two caster support arms that

extend from the right side of

the cabinet. Make sure that

the warning label is facing

outward. Use two M10 x 40

button head socket bolts, two

M10.5 x 17 lock washers,

and two M10.5 x 20 washers

to mount the caster extension

bar to the caster support arms

(see Fig. 16). Fully tighten the

bolts with a 6 mm hex key.

Fig. 15

linkage

bar slot

Raise

Never place fingers,

toes or other body parts

under the mobile base.

WARNING

1. Never

place f

inger

s, toes or

other

body

parts unde

r the mobile base.

2. Always

use th

e saw an

d the mo

bile base

on a le

vel sur

face.

3. Lower

the saw bef

ore use. N

ever u

the saw when it

is raised off the floor

4. Lower

the saw slo

wly, do not

let it

drop back to

the floor

WARN

ING

caster

support

arms

caster

extension

bar

Fig. 16