SawStop Mobile Base - Manual (Page 15)

13 SawStop Professional Cabinet Saw Mobile Base
9. Align the front end of the caster support
with the mounting hole in the lower right
corner of the front of the cabinet and
secure that end of the caster support
to the cabinet with an M8 x 20 button
head shoulder socket bolt (see Fig. 7).
Note that this bolt is different than the
bolt used to secure the rear of the caster
support to the cabinet. Fully tighten the
bolt using a 5 mm hex key.
Fig. 7
Installing Your Mobile Base - Method 2
Fig. 6
Fig. 28
8. The end of the caster support next to
the back of the saw is the end with the
mounting shoulder. Insert the mounting
shoulder through the mounting hole in
the rear of the cabinet and secure that
end of the caster support to the cabinet
with one M8 x 20 button head socket
bolt, one M8 x 13.6 lock washer, and
one M8 x 18 washer (see Fig. 6). Fully
tighten the bolt using a 5 mm hex key.
10. Locate the wheel support and the two 3 inch wheels. Note that one end of the wheel support has a mounting
shoulder and the other end does not. Mount one of the 3 inch wheels between the two support arms nearest
the end of the wheel support that has the mounting shoulder using a fixed wheel axle and an M6 lock nut from
the hardware pack (see Fig. 28). The fixed wheel axle passes through the outer support arm and threads
through the inner support arm. Fully tighten the nut using a 17 mm wrench and a 10 mm wrench.
end with a mounting
shoulder
wheel
support
3 inch wheel
support arms
7
6
5
3
4