SawStop Mobile Base - Manual (Page 12)

10 SawStop Professional Cabinet Saw Mobile Base
Installing Your Mobile Base Installing Your Mobile Base - Method 2
1. You need access to the bottom of your saw to install the mobile base. The easiest and safest way to provide
that access is to tip the saw so that it rests on the end of the front rail, as shown in Fig. 19. The saw’s center
of gravity makes it stable when in this position. Both the front and rear rails must be securely mounted on the
saw before tipping the saw.
If you already have an out-feed table mounted to your saw you will need to remove it before tipping the saw.
Also, if you have an extension table with support legs attached to your saw, you will need to remove the support
legs or rotate them out of the way. Steps 2 and 3 below describe how to rotate the support legs on a SawStop ®
T-Glide TM Professional Series II extension table out of the way. If you have not installed an extension table or
your extension table does not have support legs, skip to step 4.
. Rotate the legs on a SawStop ® T-Glide TM Professional Series II extension table out of the way by removing
the lower M10 x 40 hex head bolt that mounts each leg its support bracket (see Fig. 0). Use two 17 mm
wrenches or adjustable wrenches to remove the bolts. Also remove the corresponding M10 washers and M10
lock nuts.
Fig. 0
access
M10 x 40 hex
head bolt
M10 washers
M10 lock nut
support leg
leg support
bracket
STaRT HeRe to install your mobile base on a
Professional Cabinet Saw that has a fence system installed.
Fig. 19