SawStop T-Glide Fence System - Manual (Page 5)

Installing Your T-Glide Fence System
miter slots
front rail
Use M8 x 16 bolts
1. Begin mounting the front rail (the longer of the two rails) to the front edge of your saw by centering the notches
in the rail with the two miter slots in the table, aligning the two holes in the rail between the notches with the two
corresponding holes in the front edge of the table, and threading an M8 x 16 countersunk socket head bolt into
each hole (see Fig. 1). Aligning the two holes between the notches aligns all the other holes used in mounting
the rail to your saw. Not all the holes are used to mount the rail to your saw; different holes are used for different
saws. Thread the bolts into the corresponding holes, and tighten them using a 5 mm hex key.
notch
notch
Fig. 1
Installing your T-Glide
TM
Fence System on your
SawStop
®
Professional Cabinet Saw
SawStop
1
SawStop T-Glide Fence System - Professional Series II 3