SawStop T-Glide Fence System - Manual (Page 18)

15. Place the straight-edge lengthwise across the middle of the table (see Fig. 15a) and level the middle of the
extension table by turning the screw in the adjustment bracket with a 5 mm hex key (see Fig. 15b).
Installing Your T-Glide Fence System
16. Turn the foot on the bottom of each support
leg to adjust its position until it is in solid
contact with the ground. Once the foot is
in contact with the ground, fully tighten the
hex nut against the bottom of the leg using a
13 mm wrench (see Fig. 16).
Fig. 15a
Fig. 15b
Fig. 16
straight-edge
adjust the position of
the foot and tighten
the hex nut
adjustment screw
NOTE: The adjustment
bracket is designed for
cast iron wings only.
If you have a Contractor
Saw with stamped wings,
you may skip this step
and go on to step 16.
16 SawStop T-Glide Fence System - Professional Series II