SawStop T-Glide Fence System - Manual (Page 19)

Installing Your T-Glide Fence System
18. Locate the fence and the red fence handle. Thread
the handle into the cam lock on the front of the fence
(see Fig. 18).
17. Locate the front tube and the T-Glide Rails Hardware Pack. If you have a 36” fence system, remove seven
M8 x 16 hex head bolts and seven M8 lock washers from the T-Glide Rails Hardware Pack. If you have a 52”
fence system, remove nine M8 x 16 hex head bolts and nine M8 lock washers from the T-Glide Rails Hardware
Pack. Position the tube on the front rail with the rulers facing up and the 12-inch ruler on the left. The powder
coated surfaces of the tube and rail can be slick, so be careful that the tube does not fall off the rail. Align the
holes in the rail with the holes in the bottom of the tube. Place an M8 lock washer on each M8 x 16 hex head
bolt and insert the bolts through the rail and into the threaded holes in the bottom of the tube (see Fig. 17).
Hand tighten the bolts; do not fully tighten them.
Fig. 17
Fig. 18
SawStop
4
6
T-Glide Rails Hardware Pack
2
Countersunk Socket Head Bolts,
M8 x 25 (8)
Washers,
M8 (8) 3
Lock Washers,
M8 (17) 4
II Professional Series
Countersunk Socket
Head Bolts, M8 x 16 (8)
1
Hex Head Bolts, M8 x 16 (9) 6
Hex Nuts,
M8 (8) 5
F
thread the handle into
the cam lock
SawStop T-Glide Fence System - Professional Series II 17