SawStop T-Glide Fence System - Manual (Page 4)

Note: Your saw must be fully assembled before installing the fence system.
Note: The drawings below show how to assemble both the 52” and 36” fence systems. Although the
components shown are from the 52” fence system, the components from the 36” system are similar.
Before you begin installing the fence system, locate the front rail, the
rear rail, and the T-Glide Rails Hardware Pack (shown on the right). All
of the hardware needed to install the rails is located on the T-Glide Rails
Hardware Pack and is shipped in the T-Glide fence box. In order to easily
identify the hardware used in each of the following steps, the different
pieces of hardware are numbered on the hardware pack and in the figures.
If you are missing the T-Glide Rails Hardware Pack, the T-Glide Table
Hardware Pack, or any of the other fence system components shown on
page 1, call the SawStop Service Department at 503-582-9934.
You will also need the following tools to complete the fence assembly:
• a 13 mm wrench
• two 17 mm wrenches (or adjustable wrenches)
• a 5 mm hex key
• a level or straight-edge
The instructions for installing rails on a SawStop Professional Cabinet Saw are different from the instructions for
a SawStop Contractor Saw. The instructions for installing the extension table are the same for the Professional
Cabinet Saw and the Contractor Saw.
If you have a SawStop Professional Cabinet Saw
- begin on page 3.
If you have a SawStop Contractor Saw
- begin on page 8.
0 15 30
45
SawStop 10” Contractor Saw
SA
WSTOP
SA
WSTOP
T-Glide Rails Hardware Pack
2
Countersunk Socket Head Bolts,
M8 x 25 (8)
Washers,
M8 (8) 3
Lock Washers,
M8 (17) 4
II Professional Series
Countersunk Socket
Head Bolts, M8 x 16 (8) 1
Hex Head Bolts, M8 x 16 (9) 6
Hex Nuts,
M8 (8) 5
F
2 SawStop T-Glide Fence System - Professional Series II
Installing Your T-Glide Fence System