SawStop T-Glide Fence System - Manual (Page 20)

Installing Your T-Glide Fence System
parallelism
adjustment
screw
front tube
20. Press down on the fence handle to clamp the fence to the front tube. If the fence does not clamp tightly
enough to hold its position against a moderate amount of force, you can increase the clamping pressure by
turning both parallelism adjustment screws clockwise using a 5 mm hex key. Those screws are located in the
vertical portion of the fence cross-bracket (see Fig. 20). Alternatively, if too much force is required to push the
fence handle down to clamp the fence to the front tube, you can reduce the clamping pressure by turning both
parallelism adjustment screws counter-clockwise.
19. The holes in the bottom of the front rail are oversized to allow you to adjust the position of the tube on the rail.
To set the tube in the correct position, first pull the front tube away from the table as far as possible. Next, place
your fence down on the tube near the left end (see Fig. 19).
Fig. 19
parallelism
adjustment
screw
Fig. 20
18 SawStop T-Glide Fence System - Professional Series II