SawStop T-Glide Fence System - Manual (Page 15)

Installing Your T-Glide Fence System
8. Locate the two leg support brackets. Remove
the two M8 x 20 countersunk socket head
bolts from the T-Glide Table Hardware Pack
along with two M8 washers, two M8 lock
washers and two M8 hex nuts. Mount one
leg support bracket to the underside of each
of the rails as shown in Fig. 8a. Hand tighten
the nuts; do not fully tighten them.
Once mounted, the brackets should create
a shelf as shown in the close-up view of
Fig. 8b below.
9. Place the extension table between the rails and slide it towards the extension wing (see Fig. 9). Be careful
when positioning the extension table because it is not yet secured to the rails and could fall. You will need to tilt
the extension table slightly for the adjustment bracket to fit under the extension wing. The adjustment bracket
includes a screw that extends upward and the underside of the extension wing includes a hole to receive the
screw. Fit the screw into the hole, and then turn the screw until the extension table is roughly flush with the
extension wing. The opposite end of the extension table will rest upon the leg support brackets but will not be
level because the leg support brackets are at different elevations and are not intended to support the extension
table once it is fully installed.
Fig. 9
leg support
bracket
Fig. 8a
Fig. 8b
19
18
16
17
SawStop T-Glide Fence System - Professional Series II 13