SawStop SawStop - Manual (Page 8)

Slide the table insert toward the blade
at a slight angle.
The screws in the bottom rear of the
insert should slide under the heads of the
screws in the rear of the table opening.
To Install the Table Insert:
3.
screw in the
rear of the insert
screw in the rear
of the table opening
4.
Install the front lock-down screw.
Use a 3mm
hex key.
4.
Lift the table insert at a slight angle
and pull it away from blade.
Use a 3mm
hex key.
Table Insert
1.
Turn the saw OFF and unplug the
power cord.
.
Set the blade to 0° and raise it fully.
3.
Remove the front lock-down screw.
To Remove the Table Insert: