SawStop SawStop - Manual (Page 7)

Push the Start/Stop Paddle to OFF - The saw will not start if the paddle is pulled
out when the main power switch is turned on.
Turn the Cartridge Key to ON - Turn the main power switch OFF and reinstall the
cartridge key, turning it fully 90 degrees (see page 13).
No Blade Rotation - Make sure the power cable to the motor is connected and the
belt is installed. Press the thermal reset button on the switch box.
Adjust Brake Cartridge Position - Turn the main power switch OFF and check
the blade-to-brake spacing (see page 11).
Contact Detected During Standby - Contact was detected while the blade was
stopped. Wait 5 seconds for this code to clear.
Contact Detected During Bypass - Contact was detected during bypass mode.
This code will clear when the blade stops.
Overload Due to Wet Wood - The wood being cut is too wet or too green. To
clear, push the paddle in and turn the main power switch OFF and then ON again.
Allow the wood to dry before cutting or cut the wood in Bypass Mode.
See Owner’s Manual
? pp.39-41