SawStop SawStop - Manual (Page 6)

6
Switch Box Lights
On Solid Slow Blink Fast Blink OFF
System Startup - The system is performing self-checks. Allow 10 seconds to
clear.
System Ready - The saw is ready to run or is running in Normal mode.
Replace Cartridge - Turn the main power switch OFF and then ON again. If this
error does not clear, replace the brake cartridge (see page 12).
Coasting Down - DO NOT TOUCH THE BLADE. The brake will activate if contact
is detected during coast-down.
Bypass Mode ON - The saw is in Bypass Mode. The safety brake will not
activate in Bypass Mode.
Green light Red light
may be OFF, or it may be ON solid, ON blinking slowly, or ON blinking quickly. After system startup, the
red light goes on when there is a problem. Find the matching pattern below to identify the problem.
The red and green lights on the switch box tell you if the
saw is operating normally or if there is a problem. Each light