beautypg.com

Mittler Bros Machine & Tool 50520 User Manual

Page 2

background image

1. Set all scale pads out individually (at least 12” apart).

2. Turn on the scale pads by switching the power switch on each scale pad to

“ON” and press the reset button on the front of the black box.(Green light will

start blinking indicating power is on.)

3. Pivot the hand held antenna until the antenna is perpindicular to the floor (this

is essential for communication between the pads and hand held) and turn the

hand held on by pushing the “ON/OFF” button.

4. When the menu appears, select “Weigh Vehicle” by pressing the “OK”

button. Give the hand held a few seconds to start communication with the

scale pads. When the red lights on ALL scale pads are blinking and numbers

appear on the scaling screen the scales are ready to use. If you find that one

scale does not blink red after 1 minute, simply turn that scale off and back on

and press the reset button.

5. Zero the system (if necessary) by pushing the “MENU” button and selecting

zero all pads. This will then display zero’s in the locations selected. (this may

take a few seconds)

6. Put your racecar on the scales and the weights will register, the %’s and

totals will show on the display.

7. Turn the hand held off by pushing the “ON/OFF” button for 2 seconds.

8. Turn the scale pads off to conserve battery life.

9. The hand held unit contains rechargeable batterys, simply recharge by

plugging the power adapter into the unit. For best performance, charge

battery for 12 hours. Each scale pad contains (4) AA batteries.

If you wish to change a pad location (ex. change the RF to the LR etc.) or change

the system ID, this can be done by following these steps.

1. Set all scale pads out individually (at least 12” apart).

2. Turn on the scale pads by switching the power switch on each scale pad to

“ON” and press the reset button on the front of the black box.(Green light will

start blinking indicating power is on.)

3. Pivot the hand held antenna until the antenna is perpindicular to the floor (this

is essential for communication between the pads and hand held) and turn the

hand held on by pushing the “ON/OFF” button.

4. When the menu is displayed on the hand held, select “SYSTEM ID”. Scroll

the arrow down to the word ID and press the right arrow over to where the

name is. When a character is underlined, you can change it to whatever you

wish using the up and down arrows, this will make your system unique so no

one else with a wireless scale system can pick up on your “channel” and see

your information. Once you are finished scroll back completely to the left and

back up until the arrow is pointiong to “Save and Exit” then press “OK”.

5. Plug the communications cable into the hand held and into one scale pad.

6. Press “MENU” and scroll down past “UNITS” & “PAD SETUP” will appear.

This will allow you to change pad location and/or download a new system

ID. Scroll the arrow down until it is pointed at the pad you are plugged into

(RF,LF,RR or LR) and press “OK”. You will see a message scroll across

the bottom of the screen and the message “Pad set OK” will flash. Plug the

cable into every scale pad to complete this step, each time selecting the pad

you are plugged into. Once you have completed all 4 scale pads, you must

turn the pads off by flipping the switch to “OFF”and turn the hand held off by

pressing the “ON/OFF” button for 2 seconds.

7. Complete steps 1-5 of the scaling instructions and your scales are now ready

to be used.

8. Turn the scale pads and hand held off to conserve battery life.

CAUTION: Changes or modifications not expressly approved by the

party responsible for compliance could void the user’s authority to

operate the equipment.

Please read all instructions prior to operating scales.

Scaling Instructions

System ID / Pad Location Change