Mittler Bros Machine & Tool 50210 - Manual (Page 2)

1. Set all scale pads out individually.
2. Plug the cables into the scale pads.
3. Turn the scales on by pushing the On/Off Button. The scales will turn on and
read Tanner Racescales and show you the level of the battery. If the battery
is low you may want to charge the unit.
4. ZERO the system by pushing the UP or DOWN Arrow and selecting Zero all
pads. If you are not using all pads you may individually Zero each pad. After
you highlight the choice on the menu you may select it by pushing the OK
button. This will then display zero’s on the locations selected.
5. Put your vehicle on the scales and the weights will register, the %’s and totals
will show on the displays.
6. Shut the scales OFF by pushing the ON/OFF button for 2 seconds and the
scales will turn off.
7. Remove the cables from the scale pads and put the unit away. If the scale
needs charging you can plug the AC adapter into the scale and the battery
voltage bar will display on the top display.
If you have any questions or need technical assistance please
call 800-467-2464. Thank you and good luck racing. Push this button to turn unit ON
Push and hold for 2 seconds to turn Unit OFF
Select this button as the OK button during the
menu functions.
Push this button to enter into the menu.
This button will also allow you to scroll up.
Push this button to enter into the menu.
This button will also allow you to scroll down.
On/Off/Ok
Button Operation
Scaling Instructions