Mittler Bros Machine & Tool 3100-100 Universal Tool Stand User Manual

Page 2

Attach the bottom tray to the rear H frame using the 3/8” x 3” bolts, lock washers & nuts. Attach the top tray to “H”
frame using the 5/16” x 3” bolts, lock washers & nuts.

Install the Front Leg by slipping it between the the tabs on the bottom tray and inserting a 3/8” x 3” bolt through the
holes. Be sure that the mounting plate at the top is angled correctly as shown below. Use 5/16” x 1” bolts, lock
washers & nuts to attach the leg top plate to the Top Tray. Put the flat washers on the tray side & nuts on the frame
side.

Pre Drilled mounting holes allow a multitude of MB machines to be mounted without any drilling. Addtional machines
of yours may be mounted by drilling your own mounting holes.

BE SURE STAND IS STABLE WHEN MACHINES

ARE MOUNTED. MACHINE DAMAGE AND / OR PERSONAL INJURY MAY OCCUR IF MACHINES ARE
IMPROPERLLY MOUNTED. ALWAYS LOCK CASTER WHEN IN USE!

Thank You for Your Purchase.

We appreciate your business.

If have any questions, comments or suggestions please contact us.

1-800-467-2464 www.mittlerbros.com

Rear “H” Frame

Note Angle

Use 3/8” x 3”
Bolts, Lock
Washers & Nuts.
Put a Flat
Washer, Lock
Washer & Nut on
Tray Side.

5/16” x 1” Bolts
Lock Washers

Be Sure the Leg Top
Plate Is Installed so
the Leg is Angled
Forward.

Top Tray

Use 5/16” x 3” Bolts,
Lock Washers & Nuts.
Put Flat Washers
Under Bolt Head &
Under Lock Washer &
Nut on Frame Side.

Bottom Tray

Fully Assembled