Mittler Bros Machine & Tool 2500-400 Bend Stop - Manual (Page 2)

Digital read
Out End.
Right side
Hydraulic
Cylinder End
Left Side
Bend Stop Location.
Under Main Bender
Assm
8. Rotate the Actuator Arm Assm. until the Adjuster Bolt just touches the Air Switch Button,
then tighten down the clamping bolts the rest of the way.
9. Once the clamping bolts are tight, screw the Adjuster Bolt toward the Air Switch Button until
the button is about half way depressed. Step on the pedal and see if the pump pumps. If the
pump starts to pump let up on the pedal immediately and adjust the Adjuster Bolt in a little more.
Repeat until the pump does not try to pump any more.
10. Tighten the jam nut and then repeat the bend process and double check the bend and make any
adjustments needed to the Adjuster Bolt. This may take a few bends to get exactly what you
need.
11. Remember to remove the Actuator Arm Assm. if you not going to be making repeat bends.
KIT CONTENTS:
1ea. Mounting Bracket
1ea. Air Switch
2ea. Elbows
1ea. Pre Made Hose (goes from to pump to air switch)
2ea. ½” Hard Washers
1ea. Instruction
Sheet
We appreciate your business and hope that you enjoy your new Mittler Bros. Product. If you have any
questions or concerns please feel free to call us at 1-800-467-2464 for help.