Goulds Pumps VIC - IOM - Manual (Page 38)

1
2
3
4
5
6
7
8
9
10
11
12
13
1. Driveshaft
2. Driver key, supplied by motor vendor
3. Driver hub
4. Spacer
5. Adjusting plate
6. Pump hub
7. Pump key
8. Headshaft
9. Capscrew
10. Hex nut
11. Hex nut
12. Capscrew
13. Split ring
Figure 10: Spacer-type coupling
1. If a driver support is furnished and not installed, perform these steps:
a) Hoist the driver support and inspect the mounting surfaces and register.
b) Clean these surfaces thoroughly.
c) Install the driver support on the discharge head and secure it with capscrews.
2. Attach a sling to the lifting lugs of the driver and hoist the motor.
3. Inspect the mounting surface, register, and shaft extension, and then clean these surfaces thoroughly.
If any burrs are found, remove them with a smooth mill file.
4. Orient the motor-conduit box in the required position:
a) Align the motor-mounting holes with the mating-tapped holes on the discharge head.
b) Lower the motor until the registers engage and the motor rests on the discharge head.
c) Secure the motor with capscrews.
5. On drivers with a non-reverse ratchet or pins, manually turn the driver shaft clockwise when viewed
from the top, until the non-reverse ratchet or pins fully engage.
6. Lubricate the motor bearings according to the instructions on the lubrication plate attached to the
motor frame.
7. Make temporary electrical connections according to the tagged leads or the diagram attached to the
motor.
Installation (Continued)
36 Model VIC Installation, Operation, and Maintenance