Martin Universal Design Manchester Split-top Table - Manual (Page 8)

Manchester Split-top Table Assembly Instructions
Attach Drawer support guide (Part G) to base cross
supports (part C & E) using 2 each 6x30mm Hex bolts.
Tighten with Allen Wrench. See FIG 12.
PLEASE NOTE: Make sure the Drawer Support
guide is facing the right as in FIG 12.
STEP 8] Attach Drawer support guide
Attach 2 Hinges (Part M) to front edge Cross support
(Part E) by lining up holes in hinge and holes in cross
support E using 3 each 4x12mm screws (Part S) per
hinge. Tighten with phillips screwdriver. SEE FIG 13.
PLEASE NOTE: Make sure that the Hinge is
positioned as in FIG 13B
STEP 9] Attach Hinges to base
FIG 12
E
G
Drawer
Support
Guide
G
E
FIG 13
M
Hinges
need to be
attached as
shown at
right.
E
Front edge of base
FIG 13B
Align holes in hinges to holes in top and align holes in
tilt mechanism (Part J) to threaded holes in top.
See FIG 14
STEP 10] Attaching Base to Top
Line up holes in
hinge with holes
in top
Line up holes in
tilt mechanism
and T-nuts in top
Pg. 8
May 08- RPI
FIG 14
J