Martin Universal Design Manchester Split-top Table - Manual (Page 6)

Pg. 6
May 08- RPI
Manchester Split-top Table Assembly Instructions
Repeat with right side (part B) by attaching the other end
of the three cross supports (part C, D & E) using 1 each
6x50mm hex bolts (part N) into each hole found on the
outside side edge of Part A and lining that hole up with
the hole in the end of each cross support. Tighten hex
bolt with Allen Wrench (part C1). SEE FIG 5,6 & 7
PLEASE NOTE: The Black square caps as shown
in FIG 1 indicate the top side of Parts A & B
PLEASE NOTE: DO NOT OVERTIGHTEN HEX BOLT
to cause frame to bend.
B
C
N
N
B
D
FIG 6
FIG 7
This is what your partial assembled base should now
look like. See FIG 8.
Attach cross support (part D) to Side A
FIG 6.
Attach cross support (part E) to Side A
FIG 7.
FIG 5
N
B
E
FIG 8
STEP 3] Assembly Base of Table, cont’d
STEP 4] Assembly Base of Table, cont’d