Martin Universal Design U-DS24 BERKELEY MAXUM TABLE - Manual

BERKELEY MAXUM U-DS24 ASSEMBLY
C. Plastic Knob
A. Stand Frame
D. Hex Bolt E. Phillips Screw
1. Swing the left and right side legs out
as shown. See Fig. 1
Your new Berkeley MAXUM Table has been designed and manufactured to enhance your productivity and efficiency. This sturdy
folding table, properly assembled, will last through years of use. Follow the instructions below to assemble your Berkeley
Maxum and refer to the enclosed parts list for part identification. Tools needed for assembly: screwdriver, hammer, nail or awl,
tape measure and pencil. NOTE: Attaching Top instructions on reverse side of this sheet.
2. Put the hex bolt [D] inside the clamp (See Fig. 2)
and then attach knob [C] and tighten. (See Fig. 3)
3. Attach top to base. (Instructions on reverse side
of this sheet)
4. Once top is attached to base, to Adjust height of
table, loosen knobs on both rear collars, lift top
to chosen height/tilt. Tighten knobs to secure.
Continue by loosening front knobs on collars
and raise legs until desired front edge
height. Tighten knobs to secure.
Fig. 3
Fig. 2 Fig. 1
NOTE:
Make sure the collar is in
the correct position as
shown. See Fig. 3
Martin Universal Design, Inc. • 4444 Lawton Avenue, Detroit, MI 48208 USA
Tel: (313)895-0700 / Fax:(313)895-0709 • E-mail: [email protected]
Brackets/Hinges
ONE YEAR GUARANTEE
This Martin Universal Design, Inc. product has a one year guarantee to
be free from manufacturers defects during that period of use by the
original purchaser. Items or parts subjected to extreme temperature or
abuse or use of this product other than manufacturers intended purpose
is not covered under this guarantee.
B. Metal Guide
STOP
PLEASE DO NOT RETURN THIS TABLE to the
Store where you purchased it. If you are
unable to assemble or parts are missing,
PLEASE Call Customer Service at
Martin Universal Design, Inc.
313-895-0700 or Email: [email protected]
Any Questions with Assembly? We Can Help
ITEM# PARTS LIST QTY
97-DS240A Stand Frame 1
97-DS240B Metal Guide 2
97-DS240C Plastic Knob 4
97-DS240D Hex Bolt 4
97-DS240E Phillips Screw 14