Martin Universal Design Manchester Split-top Table - Manual (Page 10)

After sliding Drawer into table, you need to install the
drawer stop (Part X). This can be a bit tricky.
You need to position the Drawer Stop (Part X) as shown
in FIG 18 and FIG 18b, then from underneath, secure
the drawer stop with a 6x8mm Hex Bolt (Part P). Tighten
with the allen wrench.
STEP 14] Attaching Drawer Stop, cont’d
Pg. 10
May 08- RPI
Manchester Split-top Table Assembly Instructions
FIG 18
P
X
FIG 18b
FIG 19
If installed correctly, the Drawer will not be able to be
pulled all the way out of the table.
See FIG 19.
D
X
P