Martin Universal Design Manchester Split-top Table - Manual (Page 2)

STEP 1] Assemble Drawer
Begin by taking the back panel of drawer (Part Y) and
inserting 1 plastic T-nut (part K) into each hole, making
sure the hole in the T-nut is lined up with the hole in the
edge of the back panel. See FIG A.
Manchester DRAWER Assembly
PLEASE NOTE:
Assemble the Drawer FIRST before assembling the base.
Once assembled, set drawer to side.
Assembled drawer to be used later
during assembly of table.
FIG A
K Y
K
V
V
STEP 2] Assemble Drawer, cont’d.
Take the Drawer Front (Part Z) and insert the 4
Threaded Connector Pins (Part T). Use Phillips
Screwdriver to secure Threaded Connector Pins
into Drawer front.
See FIG B.
FIG B
STEP 3] Assemble Drawer, cont’d
Take the Sides of the Drawer (Parts A1R & A1L) and
insert the 2 T-nuts into the holes found on each side
panel, making sure the holes of the T-nuts line up with
the holes on the outer edge of the drawer sides.
See FIG C.
FIG C
T
Z
A1L
May 08- RPI Pg.2