Martin Universal Design Manchester Split-top Table - Manual (Page 3)

STEP 4] Assemble Drawer, cont’d
Attach sides of drawers (Parts A1L & A1R) to the Drawer
front (Part Z) by inserting Threaded Connection Pins
into the holes on the outside edge of the Drawers sides
(Parts A1L & A1R).
PLEASE NOTE: The Grooves in each side must be
lined up with each other to allow the drawer bottom
to be installed.
To secure, tighten the T-nuts found on the outer side of
the drawer sides. Turn the T-nuts until tight. See FIG D
K
STEP 5] Inserting Drawer Bottom
Slide the Drawer bottom (Part B1) into the grooves on the
sides of the drawers and into the front of the drawer.
NOTE: Brown side of drawer bottom is the bottom of
the drawer. White side up for inside drawer
bottom.
See FIG E
STEP 6] Completing Drawer Assembly
Complete Drawer Assembly by attaching the Drawer
back (Part Y) to the drawer by inserting the drawer bottom
into the groove on the drawer back. See FIG F
To secure Drawer Assembly, insert 2 each 4x35mm
screws (Part E1) into the drawer sides and tighten with
phillips screwdriver, as shown in FIG G
Manchester DRAWER Assembly
Z
A1L
FIG D
FIG E
Z
A1R
A1R
B1
B1
FIG F
FIG G
May 08- RPI Pg. 3
A1R
B1
Z
Z
A1L