Vaddio WallVIEW CCU Kit for AW HE-120 User Manual

Page 7

Quick Connect CCU Kit and WallVIEW Kit for the AW-HE120

Connector Labels and Supported Video Signals

Y/Y:

Y of YPbPr - or - Y (luminance) of Y/C on BNC-F connector

PB/C:

PB of YPbPr - or - C (chrominance) of Y/C on BNC-F connector

PR:

PR of YPbPr only on BNC-F connector

COMP:

Composite (CVBS) Video on BNC-F connector

Video RJ-45: This RJ-45 receives the camera’s four (4) differential video signals from the EZIM CCU to the
Quick-Connect CCU on Video Cat-5 cable.

Image: EZIM CCU Top Panel (left to right) and ISO View of EZIM CCU

POWER RJ-45: The EZIM CCU receives 36 VDC on one Cat-5
cable (all 4-pair) from the CCU.

Be sure to mark the Power Cat-5 and avoid plugging it
into a place it doesn’t belong.

G/L Gain Potentiometer: Adjust this level control to the level
that works with the system. This control exists to compensate for
the length of the cable used.

RS-232 IN / G/L IN RJ-45: Connect this RJ-45 with a Cat-5 cable to the RS-232 OUT / G/L OUT RJ-45 on the
back of the CCU.

Video RJ-45: This RJ-45 sends the camera’s four (4) video signals on 4-pr (differential video) from the EZIM
CCU to the Quick-Connect CCU on Cat-5 cable.

Installation:

Installation Basics:
The WallVIEW CCU system was specifically designed for installation on a vertical wall surface with Cat-5 cable
connectivity for Video, Power and Control signaling (three Cat-5 cables are required). Installation is simplified in
that no custom 8-Pin mini-din cables or expensive plenum coax cables are needed and no power outlets are
required near the camera bracket. All cabling is routed to the head-end using Cat-5 cables using standard
straight through RJ-45 connectors (568B termination). “Pass-thru” type RJ-45 connectors should never be used.

Before Installing:

 Locate the camera mounting location paying close attention to camera viewing angles, lighting conditions,

possible line of site obstructions, and checking for in-wall obstructions where the camera is to be mounted.
Pick a mounting location that will optimize the performance of the camera.

Pre-wire all cabling as required, test and mark the cables POWER, VIDEO and CONTROL. Do
not guess at the cable’s function and try the “process of elimination method” and plug the
POWER cable into all the RJ-45 jacks to see which one cable powers the camera. In all
likelihood, this method will cause damage to your system and your warranty will be voided.

EZIM CCU:
Top Connector Panel and
25-pin side connector shown

This manual is related to the following products:

Quick-Connect CCU for AW-HE120