Asante Technologies 100 - Manual (Page 33)

Enabling Traps
Page 3-21
Enabling Traps
The Trap Authentication feature enables an AsantéFAST 100 Hub stack’s
management module to generate traps. Traps are generated when cer-
tain actions — such as an unauthorized IP address attempts to access a
certain port — are violated.
To enable Trap Authentication:
1
Do not select any item on the Device Page’s front panel
image. (This selects the entire hub stack.)
2
Click Agent.
The Agent Information table appears, similar to Figure
3-20.
Figure 3-20 Agent Information table
3
Open the Trap Authentication drop-down menu and
select enabled.
4
Click Apply.
The management module is configured to generate traps.
∆
Note: For information on determining when a trap
occurs, see “Setting Alarms” on page 3-24 and “Set-
ting Port Security” on page 3-28.
For information on determining which manage-
ment stations can receive traps, see “Managing Trap
Receivers” on page 3-22.
Click Refresh to view updated information.
100NMM PM book Page 21 Wednesday, August 27, 1997 12:40 PM