Pulsafeeder Chem-Tech Series XP TIMER EN - Manual (Page 3)

REV. A PN J63143 - 3 -
1. Introduction
Thank you for your purchase of the Chem-Tech Series XP peristaltic pump from
Pulsafeeder. We appreciate your decision to purchase a Pulsafeeder product.
Please take this time to become familiar with your pump and the number of
accessories that shipped with your product.
The shipping box contains the following items:
1) Peristaltic pump comprising of: a) pump head and tube assembly, b)
Snap-on rear rain guard (this can be found in the sealed bag that shipped
with the product).
2) Instruction Manual.
3) Factory Replacement tube
4) Suction and Discharge tubing set (15-feet of ¼-inch OD Polyethylene
Tubing).
5) Injector Valve
6) Strainer w/ Ceramic Weight.
2. Safety Instructions
READ AND UNDERSTAND ALL INSTRUCTIONS PRIOR TO USE. Failure to
follow or understand instructions can/may lead to serious injury or death.
•
WARNING: Secure chemicals & metering pumps, making them inaccessible
to children & pets.
• WARNING: DO NOT PUMP FLAMMABLE LIQUIDS.
• WARNING: To reduce the risk of electrical shock-before maintenance, repair,
or moving always disconnect the power to the pump by unplugging from wall
outlet.
• WARNING: Do not tamper with, cut the plug or ground lug off the electrical
cord. Consult a licensed electrician for proper installation.
• WARNING: Always wear protective clothing, including gloves and safety eye
protection, when working on or near chemical metering pumps, consult
chemical manufacture for protective equipment recommendations.
• WARNING: Always make sure the voltage on the pump data plate matches
the installation voltage before plugging the pump into a wall outlet or hooking
up to an electrical supply. If you are unsure have a licensed electrician
inspect and install your pump.
• WARNING: Always depressurize system and drain the chemical prior to
installation or maintenance.
• WARNING: Read and fully understand the section on tube replacement.
Failure to do so may lead to serious injury.
• WARNING: DO NOT MODIFY PUMP , as this poses a potentially dangerous
situation and voids the warranty.
• WARNING: If the injection point is lower than the chemical tank and pump,
install an anti-siphon valve.