HOUNO BPE - Manual (Page 37)

BPE – Ver. 1.5x – September 2007
37
Error Codes
Error code 2: Door open (Close oven door)
Error code 3
Generator too hot (Generator thermo switch disconnected. Reconnect by
pressing button to the left behind service panel)
Error code 4:
Oven too hot (Reaction from either generator thermo-switch, oven thermo-
switch, fan thermo-switch or cold plate sensor. Reconnect generator and
oven thermo-switch to the left behind the service panel)
Error code 5:
Fan too hot (Fan too hot. Thermo-switch in motor disconnected. Wait for 10
min. And try again.)
Error code 6:
Drain too hot (Drain temperature has been too hot (above 75°C) for more
than 5 min. Check that jet in drain is working)
Error code 7: Oven sensor defective (Temperature sensor in oven not working properly)
Error code 8:
Core temp. probe not connected (A program using core temp. probe has
been chosen, but the probe has not been connected)
Error code 9:
Generator sensor defective (Temperature sensor in generator not
working)
Error code 10:
Drain sensor defective (Sensor in drain not working. The oven can still be
used)
Error code 11:
Water shortage (Steam generator was not filled within two minutes. Check
that the water has been turned on)
Error code 13:
Generator too hot (Temperature in steam generator higher than 130°C. If
error recurs, descale generator)
Error code 14: Fan too slow (At low fan speed, fan is running slower than 500 RPM)
Error code 15: Fan too slow (At high fan speed, fan is running slower than 1000 RPM)
Error code 19:
Internal defect (Oven server process does not reply. Oven server process
fails. Restart oven)
Error code 20: Internal defect (Failure in communication between computer and IO board)
Error code 21:
Invalid program (Program uses a function which the oven does not
support)
Error code 22:
Program interrupted (Power cut-out during program performance. Cut-out
has lasted so long that program cannot be restarted)
Error code 24:
Drain blocked (Steam generator could not be emptied during flushing. Level
sensor reports high water level when generator is emptied)
Error code 25:
ClimaOptima (ClimaOptima not calibrated. Enter service menu and
calibrate)
Error code 26:
ClimaOptima (ClimaOptima sensor defect. Pressure fensor does not give
correct signal)
Error code 34: Water pressure too low (Check that water is turned on)
Error code 36: Detergent insufficient (Detergent or rinse aid has run out)
Error code 38:
Detergent in oven (CombiWash interrupted, detergent in oven chamber.
Insert wash arm and run CombiWash, step 0, before oven is used.