CatEye CC-GL50 [Stealth 50] User Manual
Page 28
28
Changing the
computer
configuration
6
Click on [STEALTH] to change the settings.
Before changing the settings, click on [Read] to load the settings of the computer.
Change the settings according to the following procedure.
Setting items
Description
Time zone
Select the city code nearest from your current location.
* For details, see “Time zone list” (page 11).
Daylight saving
time
Select whether to use the daylight saving time.
• On : Moves the clock 1 hour ahead.
• Off : Displays in regular clock.
Speed unit
Select the speed unit (km/h or m/h).
Night-time set-
ting
Set the time when the backlight lights up.
• Night-time setting ON : Enter the start time when the backlight lights up.
• Night-time setting OFF : Enter the end time when the backlight lights off.
(Example) When lighting up from 7:00 pm to 6:00 am
Night-time setting ON : 19
Night-time setting OFF : 6
* When you do not want to turn on the backlight throughout the day,
set the same value for both “Night-time setting ON” and “Night-time
setting OFF”.
Setting items
Description
Tire circumfer-
ence
This setting is required when you pair the ANT+ speed sensor
or speed/cadence (ISC) sensor.
Assign the tire circumference to the speed sensor or speed/cadence
sensor whichever you pair.
(Setting range: 0100 to 3999 mm)
• ISC1 (ISC:1) : Speed/cadence sensor 1
• SPD1 (SP:1) : Speed sensor 1
• ISC2 (ISC:2) : Speed/cadence sensor 2
• SPD2 (SP:2) : Speed sensor 2
* As default, it is set to 2096.
* For the sensor without pairing, the tire circumference cannot be set
even if it is entered.
* ISC2 and SPD2 are used when a computer is commonly used for
two bicycles.
For details, see “Pairing the sensor” (page 32).
Total distance
You can enter the start value of the total distance, and add the trip
distance to it.
(Setting range: 00000 to 99999)
* This can be used when you renew and/or reset the computer.
* Enter the total distance in integer number only.
Sampling inter-
val
Set the record interval of the measurement data.
* The maximum recording time (total time of all trip data) and the
maximum time for one trip depend on the interval selected.
• 1s (at intervals of 1 second) : 35 hours / 12 hours
• 2s (at intervals of 2 seconds) : 70 hours / 24 hours
• 5s (at intervals of 5 seconds) : 175 hours / 60 hours
Clock display
format
Select the display format of “12h” (12 hours display) or “24h” (24
hours display).
* Date and clock are acquired from GPS signal; therefore, it is not
necessary to enter them.
7
Click on [Apply].
The changes are reflected to the computer.
Remove the computer from the cradle. Now, changing the computer configuration is
completed.
Delete the data recorded
in the computer.
Read the current settings
of the computer.