Power measurement, Calibration of the power sensor – CatEye CC-GL50 [Stealth 50] User Manual
Page 17
17
How to use the
computer
Power measurement
This measurement is possible when you have the ANT+ power sensor.
When the power signal is received, the middle display in the measurement screen changes
from clock to power.
* The clock display moves from the middle display to the lower display. For details, see
“Switching computer function” (page 15)
Calibration of the power sensor
Continuous use of the power sensor may cause a slight drift in unloaded condition.
Calibrate it periodically to correct the drift.
Especially for critical measurements, we recommend you perform calibration in advance.
* Read the instruction manual of the power sensor, and check the precautions for cali-
bration before you start calibration.
If you fail in calibration, accurate power measurement may not be performed.
1
Press and hold the MENU button for 4 seconds
while measurement stops on the measurement
screen
Caution:
Be sure not to put a load on the power sensor
accessories (crank, etc.) during calibration.
To the calibration screen
(press and hold for 4 sec.)
CALIB
will flash on the display, and calibration will be started.
3 seconds later, calibration will be completed and the display
will return to the measurement screen.
watt
watt
watt
Clock
0:00 – 23:59
[AM1:00 – PM12:59]
Clock
Current power
0 – 9999 watt
With power signal
3 seconds
later
Without power signal