How to use the computer, Gps search screen (when the power is turned on), Measurement screen – CatEye CC-GL50 [Stealth 50] User Manual
Page 13: How to use the, Computer, Setup of your pc
13
How to use the
computer
Power ON/OFF
This unit is a cyclocomputer, having a GPS and an ANT+ signal receiver built-in. When the
ANT+ speed sensor is not used, it can be used as a cyclocomputer using only the GPS sig-
nal; however, measurement cannot be done in an environment where the GPS signal cannot
be received. This unit has 3 screens (GPS search screen, measurement screen, and standby
screen) which are displayed alternatively according to the speed signal and/or GPS signal
receiving status and the bicycle motion status. This section describes the flow of the screen
after the power is turned on until measurement is started.
How to use the computer
GPS search screen (when the power is turned on)
When the power is turned on, the GPS search screen will appear, and the GPS signal non-
receiving icon (
) will flash. Once the speed signal is received, the speed sensor signal
icon (
S
) will flash, whereas once the GPS signal is received, the GPS signal receiving icon
(
) will light up, and the display will be changed to the measurement screen.
* In an environment where the speed signal or GPS signal cannot be received, you can
change to the measurement screen by pressing the MODE button even while either signal
is not received.
* This unit starts searching the speed signal and GPS signal after the power is turned on. It
may take several minutes to acquire the signal depending on the receiving status.
Measurement screen
This is the basic screen of this unit. This screen is used during measurement. Your can start/
stop measurement and view the data under measurement. Depending on the speed signal
and GPS signal receiving status, the computer operates in a different way as follows.
Display icon
Measurement
Viewing the mea-
surement data, and
resetting operation
Recording the
trip route
S
(Flash)
When the speed
signal is received
OK
OK
OK
(Light up)
When the GPS signal
is received
S
(Flash)
When the speed
signal is received
OK
OK
NO
(Flash)
When the GPS signal
is not received
S
(Light off)
When the speed sig-
nal is not received
OK
OK
OK
(Light up)
When the GPS signal
is received
S
(Light off)
When the speed sig-
nal is not received
NO
OK
NO
(Flash)
When the GPS signal
is not received
POWER
MODE
MODE
GPS search screen
Measurement screen
Power OFF
When the speed
signal or GPS
signal is received
When the speed
signal or GPS signal
cannot be received
Current speed
0.0 (3.0) – 105.9 km/h
[0.0 (2.0) – 65.9 m/h]
GPS signal
To be changed according
to the GPS signal receiv-
ing status.
Speed signal
Speed unit
Clock
0:00 – 23:59
[AM1:00 – PM12:59]
Date
(press & hold)
S
No operation
for 10 minutes
No operation
for 10 minutes
or
Standby screen
Changed automatically
Changed by operating buttons
No operation
for 50 minutes