ADC H2TU-C-388 - Manual (Page 19)

152-388-100-02, Issue 2 Provisioning
H2TU-C-388 List 1 June 6, 2000 11
5 Configure the maintenance terminal to the following communication settings:
• 9600 baud
• No parity
• 8 data bits
• 1 stop bit
• Hardware flow control to OFF
6 If necessary, press + to refresh the HiGain HDSL2 logon screen.
The Logon Screen
The HiGain maintenance terminal screens allow you to monitor, provision, and troubleshoot an H2TU-C-388 List
1 system.
To select a menu from the HiGain HDSL2 logon screen ( Figure 3 on page 12 ), do one of the following:
• Type the first letter of the menu.
• Use the arrow keys to select the menu and press .
Table 3 summarizes the navigational keys. They are also listed in the onscreen Help menu. Table 4 on page 12
describes the Logon screen menus.
Table 3. Navigational Keys for the HiGain Maintenance Terminal Screens
Key (a)
(a) Legacy management units require use of control keys instead of arrow keys.
Function
Cycle through selections.
Activate the current setting or choice, or display a menu.
or (VT100) Return to the parent menu.
or + Select the submenu or item above the current one, or return to the previous menu.
or + Select the submenu or item below the current one.
or + Select the menu or item to the right of the current one.
or + Select the menu or item to the left of the current one, or return to the previous menu.
+ Refresh the screen.
Most VT100 emulation programs support a print screen option. For Windows-based programs,
such as ProComm or Hyperterminal, do the following:
1 Highlight the screen that you wish to print.
2 Click File, then Print.
3 In the Print dialog box, choose Selection as the Print Range.
4 Click OK to print.
For printing procedures for other programs, contact the appropriate vendor.
CTRL R
← →
ENTER
SPACEBAR
ENTER
ESC F11
↑ CTRL E
↓ CTRL X
→
CTRL D
←
CTRL S
CTRL R