Bootp server configuration – Agilent Technologies HSSI WanProbe J3916A User Manual
Page 92
Bootp Server Configuration
72
Bootp Server Configuration
This chapter describes how to use the Bootp server method to configure the
Agilent J3916A HSSI WanProbe so that it can communicate over the network.
This chapter assumes that you have already installed the probe, but have not
attached the power cord. If you plan to use the local terminal method of
configuration, skip this chapter and refer to “Local Terminal Configuration and
Installation” on page 4.
The following sections are covered in this chapter:
z
“Probe Configuration Using a Bootp Server” on page 73
z
“Bootp Server Setup on an HP or Sun System” on page 75
z
“Bootp Server Setup on a PC” on page 79
z
See also other documents in the category Agilent Technologies Hardware:
- HP 16500B (38 pages)
- E4400-60230 (18 pages)
- Option H48 Multiport Test Set Z5623A (138 pages)
- hard disk drive kit e5052-90202 (13 pages)
- FIXTURE U7242A (10 pages)
- FS2010 (36 pages)
- USB/GPIB Interface Converter 82357A (70 pages)
- 34399A RS-232 (3 pages)
- 1100 Series (28 pages)
- N9340A (161 pages)
- 37907A (16 pages)
- N1022A (24 pages)
- Agilent E6474A (184 pages)
- 82357B (34 pages)
- Agilent E1345A (5 pages)
- 85225F (148 pages)
- 8510C (16 pages)
- Wireless Network Optimization Platform E6474A (194 pages)
- J3919A (189 pages)
- AGILENT U2761A (123 pages)
- 85032B/E 50 (55 pages)
- 8510 (32 pages)
- J6800A (16 pages)
- E6474A (14 pages)
- N2610A (248 pages)
- N6314A (7 pages)
- 85107B (20 pages)
- 8753ET (28 pages)
- N9360A (44 pages)
- Agilent 82350B (51 pages)
- Agilent 4396B (124 pages)
- LXI (8 pages)
- E1439 (246 pages)
- U2802A (67 pages)
- Agilent Hard Disk Drive Kit E5071BU (12 pages)
- U2781A (47 pages)
- E1301B (244 pages)
- Multiple Channel Controller 85330A (166 pages)
- E6701A (32 pages)
- N2620A (279 pages)
- E5810A (159 pages)
- E5805A (47 pages)